3-1 Selecting a Sensor for Configuration
If multiple Sensors are connected to a single Touch Finder or computer, you can select the Sensor that you
want to set up.
1
Press [Run].
This will enable setting the current Sensor into RUN
Mode before selecting another Sensor.
2
Then press [Switch to Run mode].
3
Press [Yes].
4
− [Switch Sensor].
Press
5
Select the Sensor to be set up.
6
Press
Mode.
7
Press [Yes].
24
Selecting a Sensor for Configuration
− [Sensor settings] to return to Setup
FQ Short Manual