Omron E5GN Datasheet page 9

Characteristics
Indication accuracy
*2
Influence of temperature
*2
Influence of voltage
Input sampling period
Hysteresis
Proportional band (P)
Integral time (I)
Derivative time (D)
Control period
Manual reset value
Alarm setting range
Affect of signal source
resistance
Insulation resistance
Dielectric strength
Malfunction
Vibration
resistance
Destruction
Malfunction
Shock
resistance
Destruction
Weight
Degree of protection
Memory protection
Setup Tool
Setup Tool port
Approved
standards
Standards
Conformed
standards
EMC
The indication accuracy of K thermocouples in the −200 to 1300°C range, T and N thermocouples at a temperature of −100°C max., and U and L thermocouples at
*1.
any temperatures is ±2°C ±1 digit max. The indication accuracy of the B thermocouple at a temperature of 400°C max. is not specified. The indication accuracy of
B thermocouples in the 400 to 800°C range is ±3°C max. The indication accuracy of the R and S thermocouples at a temperature of 200°C max. is ±3°C ±1 digit
max. The indication accuracy of W thermocouples is ±0.3 of PV or ±3°C, whichever is greater, ±1 digit max. The indication accuracy of PL II thermocouples is ±0.3
of PV or ±2°C, whichever is greater, ± 1 digit max.
Ambient temperature: −10°C to 23°C to 55°C, Voltage range: −15% to 10% of rated voltage
*2.
K thermocouple at −100°C max.: ±10° max.
*3.
"EU" stands for Engineering Unit and is used as the unit after scaling. For a temperature sensor, the EU is °C or °F.
*4.
*5.
When robust tuning (RT) is ON, the differential time is 0.0 to 999.9 (in units of 0.1 s).
*6.
External serial communications (RS-232C or RS-485) and cable communications for the Setup Tool can be used at the same time.
*1
Thermocouple:
(±0.3% of indicated value or ±1°C, whichever is greater) ±1 digit max.
Platinum resistance thermometer input:
(±0.2% of indicated value or ±0.8°C, whichever is greater) ±1 digit max.
Analog input:
±0.2% FS ±1 digit max.
CT input:
±5% FS ±1 digit max.
Thermocouple input (R, S, B, W, PL II):
(±1% of PV or ±10°C, whichever is greater) ±1 digit max.
*3
Other thermocouple input:
(±1% of PV or ±4°C, whichever is greater) ±1 digit max.
Platinum resistance thermometer input:
(±1% of PV or ±2°C, whichever is greater) ±1 digit max.
Analog input:
(±1%FS) ±1 digit max.
250 ms
Models with thermocouple/platinum resistance thermometer input (universal input): 0.1 to 999.9 EU (in units of 0.1 EU)
Models with analog input: 0.01 to 99.99% FS (in units of 0.01% FS)
Models with thermocouple/platinum resistance thermometer input (universal input): 0.1 to 999.9 EU (in units of 0.1 EU)
Models with analog input: 0.1 to 999.9% FS (in units of 0.1% FS)
0 to 3999 s (in units of 1 s)
*5
0 to 3999 s (in units of 1 s)
0.5, 1 to 99 s (in units of 1 s)
0.0 to 100.0% (in units of 0.1%)
−1999 to 9999 (decimal point position depends on input type)
Thermocouple: 0.1°C/Ω max. (100 Ω max.)
Platinum resistance thermometer: 0.1°C/Ω max. (10 Ω max.)
20 MΩ min. (at 500 VDC)
2,300 VAC, 50 or 60 Hz for 1 min (between terminals with different charge)
2
10 to 55 Hz, 20 m/s for 10 min each in X, Y, and Z directions
10 to 55 Hz, 0.75-mm single amplitude for 2 hrs each in X, Y, and Z directions
2
100 m/s , 3 times each in X, Y, and Z directions
300 m/s 2 , 3 times each in X, Y, and Z directions
Controller: Approx. 90 g, Mounting Bracket: Approx. 10 g
Front panel: IP66, Rear case: IP20, Terminals: IP00
Non-volatile memory (number of writes: 1,000,000 times)
CX-Thermo version 4.2 or higher
Provided on the side of the E5GN. Connect this port to the computer when using the Setup Tool. An E58-CIFQ1 USB-Serial
Conversion Cable is required to connect the computer to the port on the side of the E5GN.
UL 61010-1, CSA C22.2 No. 1010-1
EN 61010-1 (IEC 61010-1): Pollution level 2, overcurrent category II
EMI:
Radiated Interference Electromagnetic Field Strength: EN 55011 Group 1, class A
Noise Terminal Voltage:
EMS:
ESD Immunity:
Electromagnetic Field Immunity:
Burst Noise Immunity:
Conducted Disturbance Immunity:
Surge Immunity:
Power Frequency Magnetic Field Immunity:
Voltage Dip/Interrupting Immunity:
EN 61326
EN 55011 Group 1, class A
EN 61326
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-6
EN 61000-4-5
EN 61000-4-8
EN 61000-4-11
Basic type digital temperature controller
*4
*4
*6
E5GN
9