Omron E5 Getting Started Manual page 35

Installation
E5AN/EN
1,2,3...
3. When inserting the body of the Temperature Controller into the case, make
sure the PCBs are parallel to each other, make sure that the sealing rubber
is in place, and press the E5CN toward the rear case into position. While
pushing the E5CN into place, push down on the hooks on the top and bot-
tom surfaces of the rear case so that the hooks are securely locked in
place. Be sure that electronic components do not come into contact with
the case.
Bottom View of the E5CN
Tool insertion hole
(1)
(3)
(1)
E5AN
1. Insert a flat-blade screwdriver into the two tool insertion holes (one on the
top and one on the bottom) to release the hooks.
2. Insert the flat-blade screwdriver in the gap between the front panel and
rear case (two on the top and two on the bottom), and use it to pry and pull
out the front panel slightly. Then, pull out on the front panel gripping both
sides. Be sure not to impose excessive force on the panel.
Make sure the PCBs are
parallel to each other, and
then press the body of the
Temperature Controller
toward the rear case into
position.
(2)
Section 2-1
Tool insertion hole
(1)
(2)
(3)
(1)
E5EN
Flat-blade screwdriver
(Unit: mm)
0.4 5.0 2.0
23