E3S-R86 * Values in parentheses indicate the minimum required distance between the sensor and reflector. Note: Stable detection may not be possible of some glass wafer materials. Be sure to test whether the work can be detected. Accessories (Order Separately)
Page 3
10 to 30 V DC (including 10% ripple (p- p)) Current consumption 30 mA max. Load supply voltage: 30 VDC or less, load current: 100 mA or less (residual voltage of 1 V or less), Control output NPN open collector output, Light ON / Dark ON switching...
• The passage point of the detection object should be the central point between the reflective plate and the photoelec- tric switch. If too close to the reflective plate, an error may result. • To obtain sufficient detection performance, the E39-R1 must be used for the reflective plate unless otherwise spec- ified.
Optical axis 29.2 11.5 19.7 10.7 Emitter (A) * Two, M3 x 12 * The Mounting Bracket can also be used on side A. Connector type With Mounting Blanket Attached E3S-R16 E3S-R36 Light indicator (red) Sensitivity adjustment volume 42.3 (10) Connector M12 15.2...
Page 6
Accessories (Order Separately) ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. E009-E2-07-X In the interest of product improvement, specifications are subject to change without notice.
This manual is also suitable for:
E3s-r11E3s-r16E3s-r61E3s-r66E3s-r31E3s-r36...
Show all