Page 1
Spatter Immune Proximity Sensors E2EQ A Series of Spatter-resistant Proximity Sensors with a Teflon-coated Metal Housing * Teflon is a registered trademark of Dupont Company and Mitsui Dupont Chemical Company for their fluoride resin. Ordering Information Sensors ● Pre-wired Models...
Page 2
*1. Use within a range where the green indicator is lit. *2. The response frequencies for DC switching are average values. *3. Since residual voltage is 5 V, use it after checking interface requirements with the connection devices. D-172 Inductive Sensors...
Page 3
* The response frequencies for DC switching are average values measured on condition that the distance between each sensing object is twice as large as the size of the sensing object and the sensing distance set is half of the maximum sensing distance.
Page 4
Stainless steel (SUS304) Brass Brass Copper Brass Copper Aluminum Copper Side length of sensing object d (mm) Side length of sensing object d (mm) Side length of sensing object d (mm) E2EQ-X3D1(-M1GJ) E2EQ-X7D1(-M1GJ) E2EQ-X10D1(-M1GJ) Mild steel Mild steel Mild steel...
Sensing E2EQ-X8X1 object Note: E2EQ-X15X1 1. The load can be connected to either the +V or the 0-V line. 80(TYP) 2. Since there is no polarity, there is no need to pay attention E2EQ-X4X1-M1J Rated to the brown or blue polarity.
Page 6
Part B Part A d dia. Note: 1 . The table below shows the tightening torques for part A and part B nuts. In the previous examples, the nut is on the sensor head side (part B) and hence the tightening torque for part B applies. If this nut Effects of Surrounding Metal (Unit: mm) is in part A, the tightening torque for part A applies instead.
*1: Vinyl-insulated round cable (flame-resistant), 4 dia. 2/3 conductors (conducting cross-sectional area: 0.3 mm /insulator diameter: 1.3 mm Standard length: 2m Cable extension (through a single metal conduit): 200m max. *2: Operation indicator (red) and setting indicator (green). E2EQ-X8X1 E2EQ-X15X1 42 dia.
Page 8
30.5 dia. +0.5 ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. D055-E2-03-X In the interest of product improvement, specifications are subject to change without notice.
This manual is also suitable for:
E2eq-x4x1E2eq-x8x1E2eq-x15x1E2eq-x3d1E2eq-x7d1E2eq-x10d1...
Show all