Basic Operation; Cx-Motion-Ncf Basic Operation - Omron CX-MOTION-NCF - V1.8 Operation Manual

Basic Operation

3-2

Basic Operation

3-2-1

CX-Motion-NCF Basic Operation

Starting CX-Motion-NCF
Starting CX-Motion-NCF Using Start Special Application - Start with Settings Inherited from the I/O
Table Window Opened from the CX-Programmer That Was Installed from the CX-One
1,2,3...
The basic operations of the CX-Motion-NCF are explained here.
1. Right-click a Position Control Unit in the I/O Table Window and select Start
Special Application - Start with Settings Inherited from the pop-up
menu.
2. The CX-Motion-NCF will be started, a new project will be created, and a
Position Control Unit will be added automatically. The Position Control Unit
model will be inherited as shown below
Section 3-2
Device type inherited from I/O Tables
Position Control Unit model inherited
from I/O Tables.
17