Introduction; Intended Purpose; Equipment Components; Items Supplied - Parkside PABS 10.8 A1 - MANUAL 4 Operation And Safety Notes

Introduction

The following icons / symbols are used in this instruction manual:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Danger to life!
Explosive material!
Lithium-ion cordless drill
PABS 10.8 A1
©
Introduction
Before you use it for the first time, it is es-
sential that you make yourself fully familiar
with the functions of the appliance and
find out how to correctly handle electrically powered
tools. Read the following directions for use as well as
the safety instructions. Keep these instructions. When
handing the device on to a third party, hand these
instructions on, too.
©

Intended purpose

This appliance is designed for drilling and screwing
into wood, plastic and metal. Use the appliance only
as described and only for the purposes indicated.
Any other uses, and modifications to the appliance,
are deemed to be improper usage and may result
in serious physical injury. The manufacturer accepts
no responsibility for damage(s) resulting from
improper usage. The appliance is not intended for
commercial use.
©

Equipment Components

Gear selector switch
1
2 Button for rechargeable battery LED
3 Rechargeable battery LED (status indication)
6 GB
Keep children away from electrical
power tools!
For indoor use only!
Check that the device, mains lead
and plug are in good condition!
4 Bit garage
5 Direction of rotation switch/lock
ON / OFF switch
6
Soft-grip
7
Battery pack
8
Battery unlocking button
9
Light
10
Torque control / drill step
11
Quick-action drill chuck
12
Power supply unit
13
14 Status LED red
15 Battery charge status indicator green
16 Charging cap
©

Items supplied

1 Cordless drill driver PABS 10.8-A1
1 Rechargeable battery pack PABS 10.8-A1-1
1 Power supply unit PABS 10.8-A1-2 with charging cap
2 Bits in bit garage (CR-VPH1, CR-VPH2)
1 Carry case
1 Directions for use
©

Technical Data

Lithium-Ion Cordless Drill PABS 10.8-A1:
Nominal voltage: 10.8 V
Idle-running speed: 1st gear: 400 min
2nd gear: 1300 min
Drill chuck
clamping range: max. 10 mm
-1
-1