Sennheiser SR 300 IEM G3 - 01-09 Instruction Manual page 33

Adjusting the transmission power – "RF Power"
Advanced Menu
Tune
PEAK PEAK
0 0
Sync Settings
-10 -10
RF Power -20 -20
-30 -30
Warnings
-40 -40
AF AF
LCD Contrast
Call up
Reset
"RF Power"
IP-Address
Software Revision
Exit
Via the
Standard).
Activating/deactivating warning messages – "Warnings"
Advanced Menu
Tune
Via the "Warnings" menu item, you can activate or deactivate different warning messages.
Sync Settings
RF Power
Setting
Warnings
LCD Contrast
AF Peak
Reset
IP-Address RF Mute
Software Revision
Exit
* with color change on the standard display
Adjusting the contrast of the display panel – "LCD Contrast"
You can adjust the contrast of the display panel in 16 steps.
Resetting the settings made in the operating menu – "Reset"
Advanced Menu
Tune
PEAK PEAK
0 0
Sync Settings
-10 -10
RF Power -20 -20
-30 -30
Warnings
-40 -40
AF AF
LCD Contrast
Call up "Reset"
Reset
IP-Address
Software Revision
Exit
When resetting the settings made in the operating menu, only the selected settings for the
pilot tone and for the frequency banks "U1" to "U6" remain unchanged. For an overview of
the factory-preset default settings, refer to the enclosed frequency information sheet.
Advanced Menu
Sync Settings
RF Power
Warnings
Standard
"RF Power" menu item, you can adjust the transmission power in two steps (Low,
It is vital to observe the notes on the enclosed frequency information sheet!
Warning message*
"AF Peak"
"RF Mute"
Advanced Menu
LCD Contrast
Reset
IP-Address
"Stored"
Adjusting settings via the operating menu
PEAK PEAK RF Power
0 0
-10 -10
-20 -20
Standard
-30 -30
-40 -40
AF AF
Select the desired
setting
"Stored"
Trigger
Audio overmodulation
RF signal is deactivated (see page 16)
PEAK PEAK Reset
0 0
-10 -10
Yes
-20 -20
-30 -30
-40 -40
AF AF
Select the desired setting;
apply the setting
PEAK PEAK RF Power
0 0
-10 -10
-20 -20
Low
-30 -30
-40 -40
AF AF
Store the setting
31