Table of Contents
Advertisement
Using the transmitter
18
Easy Setup Sync
When the transfer is completed, the display
panel of the transmitter displays the
numbers of the transferred frequency bank
and channel.
Please note that the transmitter does not
automatically store the frequency bank and
channel setting.
Place the infra-red interface of the
portable receiver in front of the infra-red
interfaces of the remaining transmitters,
one after the other.
In each case, the next unused frequency
preset is transferred
from the receiver to
the
transmitter.
Store the frequency bank and channel
setting by pressing the jog dial on your
transmitters. The RF signal is activated.
You can carry out the
Sync
right-hand column) at a later time to
establish a transmission link between
transmitters and receivers.
OR:
Immediately synchronize your receivers
with your transmitters by carrying out
the
Sync
function
column).
This establishes a transmission link
between transmitters and receivers.
The
icon in the left lower corner of
the transmitter display indicates that the
Sync
function can be carried out.
–
Sync
When the transfer is completed, " "
appears on the display panel of the
transmitter. The transmitter then switches
back to the standard display.
The
automatically adjusted and stored by the
receiver. The transmission link between
transmitter and receiver is now established.
–
–
function (see
(see
right-hand
To cancel the transfer:
Press the STANDBY button
transmitter.
" " appears on the display panel of the
transmitter. " " also appears if no
suitable receiver was found.
transferred
parameters
are
on the
Advertisement
Table of Contents
