Modifying The Currently Active Interpreter Configuration; Loading A Previously Saved Interpreter Configuration - Sennheiser SDC 8000 System Manual

Configuration
Current
Select Booth
Booth = 01
Save Config.
as Config 1
Press ENTER to Save
Configuration
3 Load

Modifying the currently active interpreter configuration

You can modify the following features of the currently active interpreter
configuration:
the main target language (A-channel)
the second target language (B-channel)
the auto-relay interpretation for the interpreters (auto-floor)
To modify the currently active interpreter configuration:
1. From the central unit's operating menu, choose "
Configuration
" " and "
Select Booth
The "
2. (Carry out this step once for each booth.)
Choose the booth number and modify:
the main target language as described under "Configuring the main
target language (A-channel) of a booth" on page 88.
– if necessary – the second target language as described under
"Configuring the second target language (B-channel) of a booth" on
page 88.
– if necessary – the auto-relay interpretation for the interpreters as
described under "Enabling the auto-relay interpretation function
(Auto-floor)" on page 89.
3. After you have configured the last booth, press the EXIT key repeatedly
Save Config.
until the "
as Config 1
4. Choose "
The modified interpreter conifguration is saved and becomes effective
immediately.
Attention!
Save Config.
If you exit the "
interpreter configuration will
configuration remains unchanged!

Loading a previously saved interpreter configuration

To load a previously saved interpreter configuration:
From the central unit's operating menu, choose "
Configuration
" " and "
Load
The " " menu appears.
Configuration 1
Choose "
ENTER key.
The interpreter configuration is loaded. Since the options and the
initialization of the interpreter consoles on the central unit have
already been saved
interpretation system is immediately operational. It is therefore not
necessary to initialize the interpreter consoles again.
Configuring the SDC 8000 system
Current
" one after the other.
" menu appears.
" menu appears.
as Config 2
" or " " and press the ENTER key.
" menu by pressing the EXIT key, the
not be saved! The interpreter
Load
" one after the other.
Configuration 2
" or "
in this interpreter
Conference
",
Conference
",
" and press the
configuration, your
85