DC
1
2
3
»
4
DC
1
2
3
4
CAUTION!
Setting the AC 3 to standby mode
Press the
STANDBY
The operation indicator
The AC 3 switches to standby mode. Connected transmitters
are switched off, provided that they are powered via the BNC
sockets
RF IN 1
Disconnecting the AC 3 from the mains
The
STANDBY
button
mains. To disconnect the AC 3 from the mains:
Unplug the NT 3-1 table top power supply from the wall
socket.
The AC 3 is switched off.
Cleaning the AC 3
Liquids can damage the electronics of the device!
Liquids entering the housing of the device can cause a short-
circuit and damage the electronics.
Keep all liquids away from the device.
Do not use any solvents or cleansing agents.
Before cleaning, disconnect the AC 3 from the mains
(see page 13).
Only use a slightly damp cloth to clean the device.
button
for approx. 2 seconds.
and the 4 status LEDs
to
RF IN 4
.
does
not
disconnect the AC 3 from the
Cleaning the AC 3
go off.
13