Table of Contents
Advertisement
0110566 GV7160 UK
25/05/07
• Shake the base unit for a few moments and then empty it completely into your
sink – fig.21.
To obtain the best result, we recommend that this operation is done twice.
• Screw back and tighten up the boiler rinse cap with a coin.
• Put the boiler rinse cap cover back in place.
• T T h h e e n n e e x x t t t t i i m m e e y y o o u u u u s s e e t t h h e e g g e e n n e e r r a a t t o o r r , , h h o o l l d d d d o o w w n n t t h h e e " " r r e e s s t t a a r r t t " " b b u u t t t t o o n n t t o o t t u u r r n n o o f f f f
t t h h e e o o r r a a n n g g e e l l i i g g h h t t – fig.12.
Storing your generator
• Press the illuminated on/off switch and unplug the generator. Store the
electrical cord in its storage place – fig.22.
• Raise the lock-system hoop over the iron until it locks into place (audible click)
– fig.2.
• Your iron is then safely retained on its base. Warning: do not touch the
soleplate while still hot.
• Slot the extension cord outlet in the notch (depending on model). Take the end
of the cord support and press to return the flexible part into the base.
• Store the steam cord in its slide storage place. Take it, fold it in two so as to
make a loop. Put the end of this loop in the slide storage place then push gently
until you see the end on the other side of the slide storage place – fig.23.
• Leave the iron (and the iron rest) to cool down for 30 minutes.
• You can then put your steam generator away, carrying it by the handle – fig.1.
10:17
Page 9
GB
9
Advertisement
Table of Contents
