Table of Contents
Advertisement
In case of difficulty
Cassette decks
up.
@ Anon-recorded tape is being played.
@ Play a recorded tape.
The dubbing on Deck A and Deck B ends | @ This is due to the difference
in tape | @ A small time difference is not regarded es
at different timing.
length or to the characteristics of the cas-
a failure.
sette deck mechanisms.
The cassette holder does not open when | @ The key is pressed during recording or | @ Press in the Stop mode.
the EJECT key is pressed.
playback.
Sound is hoarse, or high frequencies are | @ The head is dirty.
@ Clean the head referring to "Cleaning the
not audible.
head section".
@ The tape is stretched or wrinkled.
@ Replace the tape.
Sound is distorted.
@ The recording level was too high.
@ Adjust the recording level referring to "Re-
cording operation on cassette deck'.
@ A tape recorded with distorted sound is | @ Replace the tape.
being played.
Recording is not initiated when the REC | @ The protection tab on the cassette has | @ Use a cassette with unbroken tab or close
key is pressed.
been broken.
the hole.
@ The cassette
holder is not closed com- | @ Close the cassette holder completely.
pletely.
@ The recording level is set to the minimum | @ Adjust the recording level referring to "Re-
position.
cording operation on cassette deck".
@ The TAPE A or B input selector is select- | @ Press the input selector key of the source
ed on the amplifier.
to be recorded.
@ Tape has been fully wound to a reel.
@ Change
the tape transport
direction
of
Deck B or insert the tape inversely.
Noise level is high.
@ The head is magnetized.
@ Demagnetize the head referring to "Clean—
ing the head section'.
@ External noise is induced.
@ install the system apart from other electi—
cal appliances and TV set.
@ The recording level was too low.
@ Adjust the recording level referring to "Re—-
cording operation on cassette deck'.
@ A tape recorded with Dolby NR ON is be- | @ Press the DOLBY NR key to B or C.
ing played with Dolby NR OFF.
Sound is vibrating.
@ The capstans or pinch rollers are dirty.
@ Clean the head referring to "Cleaning the
head section".
@ Tape is irregularly wound.
@ Wind the tape regularly by fast forwari-
ing, rewinding or playing it fully from onee
reel to another.
Notes:
1. With some tapes, a squeaky noise is produced when the tape is topped automatically. This is due to the tape protection function, and mot
a malfunction.
2.Do not use 120-minute tapes, for the tape is too thin and gets easily tangled.
3. This system is microprocessor-controlled, so malfunction may occur due to external noise or interference noise. In such a case, unphg
the power cord, plug it and turn power on again.
4.Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for thay
may deform the plastic components.
564-851-989 (En)
Advertisement
Table of Contents
