In Case Of Difficulty; Remote Control Unit - Kenwood MIDI M-85 Instruction Manual

In case of difficulty
Remote control unit
Remote control operation is not possible.
@ Batteries are exhausted.
@ The audio cords and the system control
cords are not connected properly.
@ The remote control unit is too far away
from the main system, controlling angle is
too large, or there is an obstacle in
between.
@ The source component to be operated
does not contain the analog disk, tape(s)
or CD.
@ An attempt is made to play a tape which
is being recorded in the cassette deck.
@ Replace with new batteries.
@ Connect properly referring to provided
Connecting diagram.
@ Operate the remote control unit within
the controllable range.
@ Place an analog disk, tape(s) or CD in the
source component to be played.
@ Wait until the recording is completed.
Amplifier, speakers
Sound is not output.
No sound comes out, and "PROTECT™ is
shown on the display.
Sound is not output from one of the
speakers.
Sound does not come from rear speaker,
or the sound is very low.
Sound does not come from center
speaker, or the sound is very low.
Sound becomes distorted.
A hum noise is generated when the
PHONO input selector key is pressed.
54 -85/m-959 (En)
@ The speaker cords are disconnected.
@ The VOLUME is set to the minimum
position.
@ The MUTING key of the amplifier is set to
ON and the point indicator is blinking.
@ Speaker cords are short-circuited.
@ The speaker cord is disconnected.
@ The BALANCE control is set to an
extreme position.
@ The rear speaker cord is disconnected.
@ The Dolby 3 Stereo mode has been se-
lected.
@ REAR VOL. has been reduced to the low-
est level possible.
@ MASTER VOLUME has been reduced to
the lowest level possible.
@ The rear speaker switch is at OFF.
@ The center speaker cord is disconnected.
@ Dolby Pro Logic, 3 Stereo or Presence
mode has not been selected.
@ PRESENCE VOL. has been reduced to the
lowest level possible.
@ CENTER VOL. has been reduced to the
lowest level possible.
@ MASTER VOLUME has been reduced to
the lowest level possible.
@ The center speaker switch is at OFF.
@ Connect properly referring to provided
Connecting diagram.
@ Adjust the volume to a proper level.
@ Press the MUTING key to OFF.
@ Unplug the power cord, eliminate the
short-circuiting, then turn on the power
again.
@ Connect properly referring to provided
Connecting diagram.
@ Adjust the Left/Right balance.
@ Connect properly referring to provided
Connecting diagram.
@ Select Dolby Pro Logic or the Presence
mode.
@ Adjust REAR VOL.
@ Adjust MASTER VOLUME.
@ Set the rear speaker switch to ON.
@ Connect properly referring to provided
Connecting diagram.
@ Select Dolby Pro Logic, 3 Stereo or the
Presence mode.
@ Adjust PRESENCE VOL.
@ Adjust CENTER VOL.
@ Adjust MASTER VOLUME.
@ Set the center speaker switch to ON.
@ Tone contro! is set completely to the | @ Adjust the tone control to the center.
right.
@ The audio cord from the turntable is not
inserted securely into the PHONO jacks.
@ The turntable is not grounded.
@ insert the audio cord plugs securely into
the PHONO jacks.
@ Connect the grounding wire to the GND
terminal on the rear panel.