Timer Playback Of Tape - Kenwood MIDI M-85 Instruction Manual

@ Timer playback of tape
1 Switch the power ON.
Press the POWER key 3
of the amplifier. )
2 Select the program setting mode.
@ The program No. indicators (1 to 6) blink.
3 Select the program No. to be used.
Select from 1 to 6.
7
sat
ENTER
@ The selected program No. indicator blinks.
4 Specify the day(s) of the week with the
numeric keys.
ENTER
eS a Ee ES Eee as tr
@ See page 46.
5 input the ON time with the numeric keys.
22:45PM : [2], [2], [4], [5 |
G2 T=
6 Input the OFF time with the numeric keys.
23:15PM :[2],(3], [1], [5]
C= T=T2TH=T=TET=
me Tr
Notes:
Press within 10 seconds.
Be sure to adjust the present time before proceeding to
the following.
7 Select the PLAY mode.
The timer modes are switched between PLAY and REC every time the
BAND key is pressed.
§ Select the TAPE source.
| BAND | elie
'is
(ibaa —» ITAPE!—= TUNER —> Pal
The sources are switched every time the BAND key is pressed.
9 Insert a tape and determine the playback
condition.
Select the side(s) to be played and the Dolby NR mode.
@ Timer playback is possible with either Deck A or Deck B.
However, if tapes are placed in decks, playback will begin
from Deck A.
1 0 Activate the execution of the program.
® Press the EXE. key. a!
® Select the program No. to be executed by pressing the
numeric key under which it is set.
Fy s
Tue THU
@ The selected program No. indicator lights up.
1 1 Adjust the volume and tone.
1 2 Switch the power OFF.
Press the POWER key
of the amplifier.
1. If you commit a mistake in the timer programming, press the key and re-start from the beginning.
2. If it is required to modify a program which has already been set, set a new program from the beginning.
3. When a program has previously been set in the program No. selected in step 3, the newly-set program replaces the previous program.
4. Do not operate the key or key while the time program execution has been activated; otherwise malfunction will oc-
cur.
M-85/M-959 (En) 49