Table of Contents
Advertisement
10. TROUBLE-SHOOTING
PROBLEM
The hob does not work.
The results of cooking are
unsatisfactory.
The hob smokes.
The cooking zones do not come
on during timed cooking.
The
symbol will start to flash
and the buzzer will sound briefly.
The fuses or the
magnetothermal switch of the
appliance are repeatedly
triggered.
The error code E2 is displayed.
The error code U400 is
displayed. The controls
deactivate after 1 second and
the buzzer sounds.
An ERxx or Ex error code is
displayed.
The
symbol is displayed.
The
symbol continues to
display regardless of whether a
saucepan has been placed on
the cooking zone.
48
Instructions for the User
POSSIBLE CAUSES
-
The hob is not wired in or it is not
switched on at the wall.
-
There is a power failure.
-
The fuse or the magnetothermal
switch of the appliance has blown.
-
The sensor buttons are locked
(child lock) and
is displayed.
-
The buttons are partially covered
by a damp cloth, a liquid or a
metal object.
-
Unsuitable saucepans have been
used.
-
Temperature is too high or too
low.
-
The hob is dirty.
-
Food has spilled onto it.
-
Timed
cooking
error.
-
The touch control buttons have
been activated due to food falling
on the hob, saucepans or other
objects.
-
The electronics are too hot.
-
The hob has not been connected
up correctly.
-
There is a technical fault.
-
A cooking zone has been turned
on but a saucepan has not been
placed
on
it
recognition).
-
The saucepan is not suitable for
induction cooking or its base is
too small.
-
Switch on at the wall.
-
Check power supply.
-
Replace the fuse or reactivate the
magnetothermal switch of the
appliance.
-
Unlock the sensor buttons (child
lock).
-
Remove them.
-
See "Saucepans suitable for use
in induction cooking" section.
-
Consult cooking guidelines.
-
Clean the hob once cooking is
finished. Let it cool first.
-
Use a larger saucepan.
programming
-
Check the instructions for use of
the timer.
-
Clean the surface or remove the
object. To turn off the flashing
symbol, press the same button or
turn the hob off and back on.
-
Call Technical Support or an
electrician.
-
Check the installation of the hob
and
sufficiently ventilated. See the
"Protection
section.
-
Connect
voltage.
-
Contact Technical Support.
-
The zone will only heat up when
the saucepan is present.
(saucepan
-
Use a saucepan with a suitable
diameter.
SOLUTION
make
sure
that
it
from
overheating"
the
correct
supply
is
Advertisement
Table of Contents
