Table of Contents
Advertisement
EN
2 / INSTALLING YOUR APPLIANCE
Monophase line 220-240 V ~
10A fuse or differential
Electrical outlet
2 prong receptacle +e e a a r r t t h h
CEI Standard 60083
• • ELECTRIC CONNECTION
Electrical safety must be provided by a
correct
build-in.
maintenance operations, the appliance must
be unplugged from the electrical grid; fuses
must be switched off or removed.
The
electrical
performed before the appliance is installed in
the cabinet.
Ensure that:
- the electrical installation has sufficient
voltage,
- the electrical wires are in good condition
- the diameter of the wires complies with the
installation requirements.
Your oven must be connected with a
(standardised)
3 conductors of 1.5mm2 (1 live + 1 neutral +
earth) which must be connected to a
circuit breaker
length 1.50 m approx.
During
fitting
connection
should
power
cable
Monophase 20A Counter
220-240V~ 50Hz
Power
supply cable
220-240V~
and
intermediary of a 1 live + 1 neutral + earth CEI
60083 standardised power socket or via an
all-pole cut-off device in compliance with the
installation rules.
Warning
be
The safety wire (green-yellow) is
connected to the appliance's terminal
and must be connected to the ground lead
of the electrical set-up.
In the case of connection to an electric wall
socket, it must remain accessible after
installation.
The fuse in your set-up must be 10 amperes.
If the power cable is damaged, it must be
replaced by the manufacturer, its After-
with
Sales Service Department or a similarly
qualified person to avoid danger.
8
single-phase
grid
via
the
Advertisement
Table of Contents
