Table of Contents
Advertisement
Lift up the edge of the lower heating
element a few centimetres and clean
the bottom.
Put the pizza plate support back in
place, pushing it in until it hits the back
of the oven, and push it down so that
the heating element plate is embedded
into the base itself.
When the operation is complete, damp parts should be dried thoroughly.
8.5.1 Removing guide frames
Removing the guide frames makes it easier to
clean the side parts, and it also needs to be done
whenever the automatic cleaning cycle is used
(only available on some models).
•
To remove the guide frames, pull the frame
towards the inside of the oven to unhook it
from its housing A, then slide it out of the
seats at the back B.
•
When cleaning is complete, repeat the above
procedures to put the guide frames back in.
66
Instructions for the user
Hide quick links:
Advertisement
Table of Contents
