Table of Contents
Advertisement
Instructions for the user
8.5.1 Removing guide frames
Removing the guide frames makes it easier to
clean the side parts, and it also needs to be done
whenever the automatic cleaning cycle is used
(only available on some models).
•
To remove the guide frames, pull the frame
towards the inside of the oven to unhook it
from its housing A, then slide it out of the
seats at the back B.
•
When cleaning is complete, repeat the above
procedures to put the guide frames back in.
8.6
Cleaning the pizza plate
The pizza plate (where included) should be washed separately according to the following
instructions:
Multifunction models: the stone must be cleaned after every use. Do not heat it again if
it has any encrustations.
To clean, pour 55 cc of vinegar onto the stone, leave it to act for 10 minutes, then remove
it by wiping with a metallic mesh or abrasive sponge.
Rinse with water then leave to dry.
•
Before cleaning, remove any dirt burnt onto the stone with the aid of a metal spatula or
a scraper of the kind used for cleaning glass ceramic hobs.
•
For best results, the stone must still be warm; otherwise, wash it in hot water.
•
Use metal mesh sponges or abrasive scotch-brite pads, dipped in lemon or vinegar.
•
Never use detergents.
•
Never wash in the dishwasher.
•
Never leave the stone to soak.
•
The damp stone must not be used for at least 8 hours after the end of the cleaning
procedures.
•
Over time, slight cracks may appear on the surface of the stone. This is due to the
normal expansion of the stone's finishing glazes at high temperatures.
71
Hide quick links:
Advertisement
Table of Contents
