Smeg SC388X-8 Manual page 37

Instructions for the user
10.7.1 Before starting the automatic cleaning cycle
Pyrolysis may be carried out at any time of the day or night (if you wish to benefit
from the lower cost of electricity overnight).
• Completely remove all accessories
from inside the oven. The roof liner is
not considered an accessory and
must therefore be kept inside the
oven.
• Remove the guide frames, see "10.6
Removing guide frames".
• At the end of the cleaning cycle, when
the oven has cooled down, reinsert
the frames by repeating the previously
used procedure in reverse order.
• Make sure that the oven door is firmly
closed.
In order not to damage the internal glass panel, it should be cleaned in
accordance with the usual procedure (see 10.4 Cleaning the door glazing)
before starting the automatic cleaning cycle.
For very stubborn encrustations, lock the door using the pins provided and
remove the glass panel. Spray an oven cleaning product onto the glass (read
the warnings on the product); leave for 60 minutes, then rinse and dry the glass
using kitchen roll or a microfiber cloth. After carrying out these operations,
position the glass panel on the door again and remove the pins locking it.
Refer to the following diagram for setting the cleaning cycle duration:
CLEANING
DURATION
During the automatic cleaning cycle, the fans produce a more intense level of
noise due to a greater rotation speed; this is entirely normal and intended to
facilitate heat dissipation.
At the end of pyrolysis, the fans will continue to operate for long enough to avoid
overheating the walls of adjacent units and the front of the oven.
LIGHT DIRT
90 MIN.
MEDIUM DIRT
135 MIN.
HEAVY DIRT
180 MIN.
89