Smeg PL8210X-1 Instruction Manual page 15

User instructions
ANNULLING A PROGRAM
To annul the program, keep the START/PAUSE button (2) pressed until
the program is interrupted (light on and confirmation beep).
Press button (2) again and keep it
pressed until the lights 4 and 5 (marked
"end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph " ". The program will resume from the
S
TARTING THE PROGRAM
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
HALF LOAD WASH SETTING
(available in all programs except the soak program)
This function is ideal for small loads and saves
water and electricity. It is controlled by the HALF
LOAD button (5) and allows washing in the
upper basket only.
IMPORTANT: at the end of the program
remember to deactivate the function to ensure
the next wash is not also carried out in half load
mode by mistake.
A cutlery basket can be placed in the upper basket, while the lower
basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the
lower basket, since the jet of water will only reach the upper basket.