Smatv Scanning; Reset To Factory Defaults - Samsung DSR 9500AT Instructions For Use Manual

1.6 SMATV Scanning

In case that several generations use Antenna and LNB
in common, search the service the from 950 to 2150MHz.
Select Searching Type "Automatic" or "Manual".
Select Scan Mode "All" or "Only Free".
You can input alternative symbol rate from 1 to 4
N N o o t t e e : 1. When your searching type is set to Automatic
during SMATV scanning, you have only to enter
the alternative symbol rate(1~4) you want.
2. When your searching type is set to Manual
during SMATV scanning, you must enter both
frequency and symbol rate.
When you select "Automatic", STB will search all available
channels based on symbol rates over whole frequencies.
On the other hand, it will scan channels with exact
information for symbol rate and frequency on "Manual".

1.7 Reset to Factory Defaults

This is to recover the Factory set values in case the user
has encountered some problems after changing any
values of channel data and others which may be in error.
The screen display will be as follows:
At the request window,
if you press key, the receiver will be reset to factory
default settings automatically.
N N o o t t e e : This cause your previous settings to be deleted!
OPERATING THE RECEIVER
GB-20
D I G I T A L S A T E L