Table of Contents
Advertisement
8. INSTALLING THE APPLIANCE
8.1
This appliance is in class 3. The procedures required below must be
carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal,
solid wood and wood finished with plastic laminates, provided the material
is heat-resistant (T 90° C).
8.1.1 Fixing to the supporting structure
To install the appliance the opening "B" and the holes "A" shown in figure 1
must be made in the top. The foam rubber strip "C" (Fig. 1) is supplied with the
appliance, and must be fixed with its adhesive side facing towards the
supporting surface. Figures 4, 5, 6, 7 and 8 show the sizes of the holes and
openings required and their respective distances from the outside of the hob,
shown by the dotted line. Make sure that there is at least 750 mm between
the hob burners and any shelving placed vertically above them (Fig. 2). If the
top is more than 20 mm thick, the hole required to install the hob is shown in
figure 4.
1)
3)
WARNING: IF THE BURNER CLOSEST TO THE SIDE WALL IS THE
FISH BURNER, THE DISTANCE "X" (Fig. 2) FROM THE SIDE WALL
INCREASES FROM 100 mm TO 300 mm.
44
Instructions for the Installer
Fitting the appliance in the top
2)
The distance "Y" is the difference
between the total thickness of the
top and the depth of the hole ø7,
which is always 20 mm.
Advertisement
Table of Contents
