Table of Contents
Advertisement
Mirrors
6
Adjusting mirrors
116
Turn the mirror to the desired
z
position.
Adjusting mirror arm
Push protective cap 1 over the
threaded fastener of the mirror
arm up to expose the threaded
fastener.
Loosen nut 2.
Turn the mirror arm to the ap-
propriate position.
Tighten the nut to the spe-
cified torque, while holding
the mirror arm to ensure that
it does not move out of posi-
tion.
Mirror (locknut) to clamp-
ing piece
22 Nm (Left-hand thread)
Push the protective cap over
the threaded fastener.
Headlight
Headlight beam throw and
spring preload
Headlight beam throw is gener-
ally kept constant when spring
preload is adjusted to suit load.
Spring preload adjustment might
not suffice only if the motorcycle
is very heavily loaded. Under
these circumstances, headlight
beam throw has to be adjusted
to suit the weight carried by the
motorcycle.
NOTICE
If there are doubts about the cor-
rect headlight beam throw, have
the setting checked by a special-
Advertisement
Table of Contents
