Table of Contents
Advertisement
Using the menus (Continued)
■ The default setting menu
This menu shows placement status and other settings.
Default setting 1 menu
Item
No signal
Set the time to wait for the power to be turned off after the last
power off
operation is made with no input signal.
Auto input
Set whether the input with signals is only selected or not.
search
Beep
Beep when operation is made.
Sets whether to turn on the power when the ON/STANDBY button is
Power on
pressed (Manual), or when the power cord is plugged in (Auto).
Sets the lamp power.
Lamp power
Detailed description
[Auto input search]
[On]: Automatically searches the signals that
can be projected, and switches input
from the connected device that outputs
the video signals each time the INPUT
button is pressed. The input from the
connected device that outputs no video
signals is skipped.
[Off]: Displays the Input select menu.
Toggle with
buttons and press
button. (The input without signals can be
selected.)
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come
on once power is restored.
[Lamp power]
[Standard]: The screen becomes a little brighter, but the cooling fan noise gets
louder.
[Low]:
The screen becomes a little darker, but the cooling fan noise gets
quieter.
Description
Off (not turned off)
30 min.
On
On
Manual
Low
Standard
Input select menu
Input select
Computer 1
Y/P
/P
1
B
R
Computer 2
Y/P
/P
2
B
R
Video
S-video
/ shows whether signal is
input or not.
40
Default setting 2 menu
Item
Projection
mode
Fan mode
Key lock
Off
Reset all
Off
Password
Auto
Detailed description
[Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan
noise gets louder.) Set this option to use the projector, for example, at high altitude
(over 1,500 meters above sea level).
• Do not set Fan mode to [High] when using the projector at a lower altitude.
[Key lock]
Protect from operating errors by locking on the control panel buttons of the
projector. (The remote control operations are available.)
Control panel operations are locked after the setting is done, and accordingly
operation with the control panel buttons is disabled.
• To release the key lock, set the [Key Lock] to [Off] using remote control. Pressing
the [RETURN] button on the projector for 10 seconds also sets the [Key Lock] to
[Off]. (When operating the main unit, the 2 indicators of LAMP and TEMP light in
orange for 3 seconds, and at the same time the projector beeps.)
Description
Sets projection mode in accordance with Placement Style.
(Standard)
(Rear)
Sets the cooling fan speed.
Lock the control panel buttons.
[
or
: Enter setting mode]
[
[
:Confirm]
[
:Select OK to end]
Press [Cancel] to return.
Press
. (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings.
Password setting
p.31
41
p.20
(Ceiling)
(Rear ceiling)
Standard
High
: Select On/Off]
Yes
No
Advertisement
Table of Contents
