Installation And Switching On The Appliance - Smeg FD54PXNF1 Instruction Booklet

No-frost refrigerator
Table of Contents

Advertisement

• The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, un-
less they have been given supervision or instruction concerning use of the appli-
ance by a person responsible for their safety. Children should be supervised to en-
sure that they don't play with the appliance.
• If the supply cord is damaged it must be replaced by the manufacturer or service
agent or appointed person.

Installation and Switching On The Appliance

• This appliance is connecting to 220-240V and 50 Hz.
• You can offer help from the service to install and switching on the appliance without
any cost.
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
• If the socket does not match the refrigerator plug, replace the plug with a suitable
one (at least 16 A)
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact, we suggest you call an electrician for assistance.
• Manufacturer is not responsible for failure to complete the ground connection as
described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-venti-
lated position. The refrigerator should be at least 50 cm from
radiators, gas or coal stoves and 5 cm far from electrical stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a minimum distance of 2 cm to prevent condensation.
• Install the distance adjustment plastic (the part with black vanes
at the rear) by turning it 90° to prevent the condenser from touch-
ing the wall.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• In order to have air circulation under the appliance, the space
under the appliance must be open. Don't close it with carpet ,
etc.
• The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in lukewarm
water. After drying replace all the accessories.
UK - 3 -

Advertisement

Table of Contents
loading

Table of Contents