Preparing The Appliance For Operation - Smeg FD24AP Manual

DESCRIPTION OF THE APPLIANCE,
BASIC PARTS
! THE APPLIANCE
LISTED BELOW MAY DIFFER FROM THE
ACCESSORIES OF THE APPLIANCE YOU
HAVE BOUGHT IN QUANTITY AND IN
DESIGN. THIS DESCRIPTION IS ADAPTED
FOR ENTIRE GROUP OF REFRIGERATOR-
FREEZER COMBINATIONS.
Fig. 1
A – refrigerator compartment
B – freezer compartment
1. Pull-out shelf
2. Interior light block
3. Thermostat knob
4. Adjustable height shelves
5. Glass shelf
6. Drawer for vegetables and fruits
7. Door trays
8. Bottle tray
9. Bottle holder
10. Thaw water channel cleaner (red colour)
11. Wire shelf
12. Supports
13. Levelling foot
14. Condenser
15. Compressor
16. Thaw water drip tray
17. Rubber sealing gasket
18. Electricity supply cord
PREPARING THE APPLIANCE FOR
OPERATION
! It is recommended to prepare the
appliance for operation with a helper.
• Remove package.
• Lift the appliance away from foamed
polystyrene base.
• Tear off adhesive tapes.
• Remove all red-coloured parts from the
shelves (fig. 2). Tear away the red-coloured
adhesive tapes from the door trays – they
are intended only for the transport of the
appliance.
ACCESSORIES
17
! If you have purchased a refrigerator with
vertical boor handles:
• Take the handles out of the bag and
screw them onto the refrigerator door.
• Cover the heads of the screws with the
little caps that you will find in the bag
POSITIONING
• Place the appliance in a dry, well ventilated
room.
• The appliance should not be operated
in an unheated room or porch.
appliance away from heat sources such
as kitchen stove/oven, radiators, or direct
sunlight.
• The appliance must not touch any pipes
for heating, gas or water supply, or any other
electrical devices.
• Do not cover the ventilation holes at the
top of the appliances– it must be a good air
circulation around the appliance. There should
be a gap of at least 10 cm between the top
of the appliance body and any furniture that
may be above it (fig. 5). If this requirement
is not followed, the appliance consumes more
electrical energy and its compressor may
overheat.
• If the appliance is placed in a corner, a
gap of at least 1 cm must be left between the
appliance body and the wall so that the door
can be opened enough to pull out the drawer
for vegetables and fruits (fig. 5).
• The appliance must stand on a level
surface and must not touch the wall.
necessary, regulate the height of the
appliance by adjusting the levelling feet 13
(fig. 1): by turning them clockwise – the
front of the appliance rises, by turning them
counter clockwise – it comes down. If the
appliance is tilted slightly backward – the
doors will close by themselves.
GB
Place the
If