Interruption Of A Program; To Change A Program; Stopping A Program - Smeg DWF410SS Instruction Manual

User instructions

INTERRUPTION OF A PROGRAM

In order to interrupt a running program it is necessary:
•
to press the START/STOP (5) for some seconds until when the
writting "Time to end" remains lit on the display (confirmation beep).
At this point,it is possible to start the cycle again, otherwise:

TO CHANGE A PROGRAM

To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
• to press again the START/STOP button (5) to make start the new
program.

STOPPING A PROGRAM

To stop a program in progress, it must first be interrupted
(see "I
NTERRUPTION OF A PROGRAM
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
The display will show "P0" and the dishwasher will immediately switch to
the end of the cycle and drain the tank (during this process, the
"Time to end" message willflash).
When the drain procedure ends, the end of cycle message "End"
appears on the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "S
TART PROGRAM
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
If the dishwasher door is left open or is not properly closed, the
INFORMATION DISPLAY (8) will signal that the washing program
cannot be started.
NTERRUPTION OF A PROGRAM
").
". The program will resume from the point in
");
41