Water Hardness Table - Smeg DWF410SS Instruction Manual

User instructions
To access the programming environment, the appliance must be turned
on with the door open. Then proceed as follows:
•
press the ECO DRY (3) button until the H symbol appears on the
display, followed by the number 3, > H3;
• press the PROGRAM DELAY (4) button the number of times
needed to select the right setting level for the hardness of the water
(H0, H1, H2, H3, H4, H5);
• press the START/STOP (5) button to confirm the setting and return
to the program setting menu.
N.B.: after 2 minutes, the appliance exits the parameter setting menu
automatically.
The value entered for this parameter establishes whether or not
regeneration is to be carried out at the end of the washing cycle, on the
basis of the table below.

WATER HARDNESS TABLE

WATER HARDNESS
German Degrees (°dH) French Degrees (°dF)
< 9°
< 15°
< 23°
< 34°
< 46°
< 58°
Contact your local water board for information on the hardness of your
water supply.
N.B.: a cycle is a washing program.
SETTING REGENERATION
< 15° H0
Performed every 6 cycles
< 25° H1
Performed every 5 cycles
< 40° H2
Performed every 3 cycles
< 60° H3
Performed every 2 cycles
< 80° H4
Performed every cycle
< 100° H5
Not performed
45