Table of Contents
Advertisement
Installation
4
The FortiExtender device is designed for placement near a window (desk or wall mount) to
achieve the best LTE signal strength. Refer to the diagram below for proper placement and
mounting.
Place on top of a desk or flat surface
1. Attach the rubber feet to the four corners on the bottom of the unit.
2. Place the unit on a desk or flat surface.
3. Secure the unit in place with a Kensington lock.
4. Attach the antennas.
14
Hang on a wall
1. Peel off the drill template sticker, and stick it onto the wall in a desired location.
2. Use the template to mark and drill the pilot holes.
3. Insert the anchors into the holes.
4. Insert the screws into the anchors and tighten, leaving around a 5-mm gap between
the screw head and the wall.
5. Position the device so that the mounting holes line up with the screws.
6. Place the mounting slots over the screws and slide the device down until the screws
fit into the slots.
Tip:
Use bear claw screws. The screw heads of bear claw screws have a built-in gap
that fits well with the hanging holes. You can purchase bear claw screws from a
local or online hardware store.
15
Advertisement
Table of Contents
