Smeg CS18A-6 Manual page 32

11.2 Removing the door
Open the door completely and fit the pins (supplied) into the holes from the
inside. Close the door to an angle of about 45°, lift it and remove it from
its seat. To replace, fit the hinges into the grooves provided, then lower
the door until it comes to rest and extract the pins. If the pins are lost, two
screwdrivers can also be used.
11.3 Oven door seal
To permit thorough cleaning of the oven, the seal can
be removed. Before removing the seal, take off the
door as described above. Once the door has been
taken off, lift the tabs at the corners as shown in the
figure.
11.4 Greasing the gas taps
Over time, the gas taps may become stiff or jam. Clean their insides and
change their lubricating grease. This operation must be carried out by
a skilled technician.
66
Instructions for the user