Marking Track Numbers While Recording (Track Marking) - Sony MDS-302 Operating Instructions Manual

Recording on MDs
ae cae ee ee
Marking Track Numbers While
Recording (Track Marking)
You can mark track numbers either manually or
automatically. By marking track numbers at specific
points, you can quickly locate the points later using the
AMS Function or Editing Functions.
EDIT/NO YES @ REC
Marking track numbers manually (Manual
Track Marking)
You can mark track numbers at any time while
recording on an MD.
Press @ REC at the place you want to add a track mark
while recording.
Marking track numbers automatically
(Automatic Track Marking)
The recorder adds track marks differently in the
following cases:
e When recording from CDs or MDs with INPUT at
DIGITAL and the source connected through
DIGITAL IN:
The recorder marks track numbers automatically.
When you record from a CD or MD, the track
numbers are written as they are found on the
original.
e When recording with INPUT at ANALOG and the
source connected through LINE IN, or when
recording from DAT with INPUT at DIGITAL and
the DAT connected through DIGITAL IN:
The recorder marks a new track number whenever
the signal level drops and rises to a certain point*
(Automatic Track Marking). If "LEVEL-SYNC" does
not light up, set the LevelSync to ON as follows:
1 Press EDIT/NO to display "LevelSync ?" during
recording or recording pause.
2 Press YES twice to display "LevelSync ON."
"LEVEL-SYNC" appears in the display.
To cancel Automatic Track Marking
1 Press EDIT/NO during recording or recording pause.
"LevelSync ?" appears in the display.
2 Press YES.
3 Press EDIT/NO.
"LevelSyncOFF" appears in the display.
* The signal level must remain low for 2 or more seconds
before a new track number is written.
'CY When you want to mark track numbers after you've
done the recording
Use the Divide Function (see "Dividing Recorded Tracks"
on page 20).