Editing Recorded Mds; Notes On Editing; Erasing Recordings (Erase Function) - Sony MDS-302 Operating Instructions Manual

Editing Recorded MDs
Notes on Editing
If "Protected" appears in the display
The recorder could not erase the specified track because the
record-protect slot on the MD is open. Erase the track after
closing the slot.
When "TOC" flashes in the display
Do not move the recorder or pull out the AC power cord. After
editing, "TOC" lights continuously until you eject the MD or
turn off the power. "TOC" flashes while the recorder is
updating the TOC. When the recorder finishes updating the
TOC, "TOC" goes off.
aia en save en
Erasing Recordings (Erase
Function)
Do the procedures below to erase following:
e A single track
e All tracks
e Parts of a track
Note, however, that once erased, MD data cannot
be recovered.
KK AMS >i EDIT/NO YES
x
arnaw 4
Erasing a single track
You can erase a track simply by specifying the
respective track number. When you erase a track, the
total number of tracks on the MD decreases by one and
all tracks following the erased one are renumbered.
Since erasing merely updates the TOC, there is no need
to record over material.
¢ To avoid confusion when erasing multiple tracks, you
should proceed in order of high to low track number to
prevent the renumbering of tracks that have not been
erased yet.
Example: Erasing B
Track 1 2 3 4
number
pate] « | œ
Erasing ; ae f i B is erased ,/
l 1 z 2 oe 3
1 Turn AMS until the track number you want to erase
appears in the display.
2 Press EDIT/NO repeatedly until "Erase ?" appears
in the display.
The track number you selected starts flashing in the
music calendar.
3 Press YES.
When the track selected in Step 1 has been erased,
"Complete" appears for a few seconds and the total
number of tracks in the music calendar decreases by
one.
If you erase a track during playback, the track
following the deleted track begins playing
afterwards.
4 Repeat Steps 1 to 3 to erase more tracks.
To cancel the Erase Function
Press EDIT/NO, W, or turn AMS to change the track number.
Note
If "Erase!! ?" appears in the display, the track was recorded or
edited on another MD recorder and is record-protected. If this
indication appears, press YES to erase the track.
Erasing all tracks on an MD
Erasing a recordable MD deletes the disc name, all
recorded tracks, and titles (see page 24).
1 While the recorder is stopped, press EDIT/NO
repeatedly until "All Erase ?" appears in the display.
2 Press YES.
All tracks in the music calendar start flashing.
3 Press YES again.
When the disc name, all recorded tracks, and titles
on the MD have been erased, "Complete" appears
for a few seconds and the music calendar
disappears.
To cancel the Erase Function
Press EDIT/NO or E.
19