Table of Contents
Advertisement
Section 2 - OPERATING INSTRUCTIONS
2.3.4. MOWER BLADE
1. With engine running, move engine speed
control to the Rabbit or "fast" position.
2. Pull the blade switch out or into the "ON"
position to engage the mower blades.
3. Release the parking brake.
4. Move joystick carefully in the desired
direction to propel the riding mower. A small
movement of the joystick can cause the power
unit to move instantly. Move joystick carefully
and slowly.
2.4 STOPPING
2.4.1. ENGINE
1. Stop engine by turning key to the "OFF"
position. Refer to Figure 2.6.
CAUTION
Before leaving the Riding Mower with the engine
running, push blade switch in to STOP blade, move
joystick to neutral and engage the parking brake.
Turn key switch to the OFF position._
2.4.2. WHEEL DRIVE
1. Stop motion of riding mower by moving
joystick to neutral (N) position. See Figure
2.7.
FIGURE 2.7
2.4.3. MOWER BLADE
1. Push the blade switch in or "OFF" position
to disengage or stop the mower blades. Refer
to Figure 2.6.
CAUTION
Once blades are disengaged, they should come to a
complete stop in 7 seconds. If the blades continue to
rotate after 7 seconds, the electric clutch should be
checked. Replacement of electric clutch may be
necessary. DO NOT CONTINUE to operate mower if
blades fail to stop in 7 seconds._
2.4.4. PARKING BRAKE
1. Engage parking brake by pulling the
parking brake lever back to the "ON"
position.
2. Release parking brake by moving brake
lever down to the "OFF" position. See
Figure. 2.8.
FIGURE 2.8
2.4.5. CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any
position, using deck lift switch. When in
desired height of cut, release switch. See
Figure 2.9. Observe the height of cut decal
located on the upper right top side of the deck
to place deck at the correct height of cut. See
Figure 2.9. NOTE: The engine does not have
to be running to adjust cutting height, but key
switch must be in the "ON" position.
FIGURE 2.9
Advertisement
Table of Contents
