Troubleshooting Guide - Blodgett ZEPH-200-G Installation Operation & Maintenance

Table of Contents

Advertisement

POSSIBLE CAUSE(S)
SYMPTOM: Oven will not fire.
Gas turned off.
Oven not plugged in.
Power switch on the control panel is off.
Control set below ambient temperature.
Doors are open.
SYMPTOM: Oven does not come to ready.
The oven has not reached preheat temperature.
Gas valve not turned on completely.
The quick disconnect is not connected.
Gas pressure to oven is too low.
Internal problem with main temperature control.
SYMPTOM: Convection fan does not run.
Oven is not plugged in.
Circuit breaker tripped.
Doors are open
SYMPTOM: General baking problems.
Thermostat out of calibration.
Improper oven venting.
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, how-
ever, that All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator.
Blodgett cannot assume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.
SUGGESTED REMEDY
Turn the gas valve to ON.
Plug in electrical supply cord.
Set the control panel to COOK or OVEN ON.
Set to desired cook temperature.
Close doors.
Wait for oven to reach preheat temperature.
Check the gas valve, turn on fully if necessary.
Reconnect the quick connect. Check all gas
connections.
Call your local gas representative.
*
Plug in electrical supply cord.
Reset the breaker.
Close doors.
*
*
23
Maintenance

Troubleshooting Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zeph-100-g

Table of Contents