Panasonic SC-AK57 Operating Instructions Manual page 39

| Using the timer
Using the loyer) timer
ke num ou o
If you set the timer incorrectly
Repeat the procedure from step EX.
To check settings
While the unit is on and the "© PLAY" (or © REC) indicator is on,
press [CLOCK/TIMER] so "© PLAY" (or © REC) appears on the
display.
Two seconds after "© PLAY" (or © REC) appears, the settings are
displayed in the following order.
$ For play timer
(1) Play start time
@) Play end time
© Play source
@) Playback volume
eFor record timer
@ Recording start time
@) Recording end time
@) Recording source
To enjoy the desired source after the timer setting is com-
pleted
The volume level and music source are stored in the timer memory
and the timer will start in these preset conditions. However the Disc
number and reverse mode do not get stored in the timer memory.
1. After step KE, turn on the unit and start playing the desired
source.
2. Reset the Disc number and reverse mode if you have changed
any of them, confirm that a Disc or cassette is inserted, then
press [POWER] to put the unit on standby.
Turning the timer ON/OFF
One of the timers is on when the [© PLAY/® REC] button is alight.
When the unit is on (or off and NORMAL mode) you can confirm
which is on by checking the indicators on the display.
When the unit is off and in ECO mode, press [CLOCK/TIMER].
The display will then show which timer is on and the settings that
have been made (see above).
To change the timer, press [© PLAY/O REC}.
Each time the button is pressed the setting changes as follows.
© PLAY © REC— (off)
|
elf the power is on, the timer will not function. The system must be
in the standby mode.
eif you switch the power to the standby mode while the play/record
timer is functioning, the OFF time setting will not be activated.
è |f "AUX1/2" or "6CH DISCRETE INPUT" is selected as the source,
when the timer comes ON, the system will turn ON and will en-
gage "AUX1/2" or "6CH DISCRETE INPUT" as the source. If you
want to playback or record from a connected component, set the
component's timer to the same time. (See the instruction manual
that came with the component.)
©The play timer cannot be used in combination with the record
timer.
Ne an.
This timer turns power to your system OFF at the set time (Max.
2 hours, settable at 30 minute intervals). It lets you fall asleep lis-
tening to music.
by remote control only
The figure shows how to set the system to standby mode after
30 minutes.
-—_ —-— s
|
|
|
|
|
|
| '
|
|
|
am
While enjoying the desired source:
Press [SLEEP] to select the desired time.
Every time you press the button;
fö 30—60—90—1 aoe)
The system is turned off after the set time has elapsed.
To cancel the sleep timer:
Press [SLEEP] to select "OFF".
To confirm the remaining time:
(only while power is ON)
Press [SLEEP].
To change the time remaining during operation:
Press [SLEEP] to show the remaining time then press [SLEEP] to
select the desired time.
eThe sleep timer turns OFF automatically the moment you attempt
to edit-record a CD using CD Manager function.
The sleep timer can be used in combination with the play/record
timer.
The sleep timer always has priority.
Be sure not to overlap timer settings.
Timer and others | |
RQT4802