Setting Up Home Connect; Activating Wi-Fi On The Appliance; Deactivating Wi-Fi On The Appliance; Resetting The Appliance Network Settings - Siemens WM14UPHSES User Manual And Installation Instructions

16.2 Setting up Home Con-
nect
Requirements
¡ The Home Connect app is installed
on your mobile device.
¡ Wi-Fi has been activated on the
router.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
Use the Home Connect app to
1.
scan the QR code.
Follow the instructions in the
2.
Home Connect app.
16.3 Activating Wi-Fi on the
appliance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press repeatedly until the dis-
3.
play shows On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
for approx. 3
16.4 Deactivating Wi-Fi on the
appliance
Press and hold
1.
three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press repeatedly until the dis-
3.
play shows OFF.
a Wi-Fi is deactivated.
Note: The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.5 Resetting the appliance
network settings
Press and hold
1.
3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press .
3.
a The display shows YES.
Press .
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press .
– Press .
– Switch off the appliance.
– Following a power cut.
Home Connect en
for at least
for at least
37