Table of Contents
Advertisement
Volume control
• Short press
/
to increase or decrease the volume. The indicator
will light up as follows:
Min volume
50% volume
Max volume
• The LEDs will fl ash when you cannot lower or increase the volume
any further.
Dolby Audio Processing
• Short press
to turn Dolby Audio Processing ON or OFF. Dolby
Audio Processing up-mixes or down-mixes audio content to optimise
it for the soundbars 2.0.2 ch speakers.
DAP ON
DAP OFF
• DAP does not work with Dolby Atmos signals.
Dolby Virtualiser
• Long press
to turn the Dolby Virtualiser ON or OFF. With the
setting turned to ON, you can experience a virtual surround sound
without the need for extra speakers.
Dolby
Virtualiser ON
Dolby
Virtualiser OFF
Dolby Atmos
When Dolby Atmos content is detected, the Dolby Atmos LED will turn
on.
Dolby Atmos
content
detected
• You can only enjoy Dolby Atmos content when using the TV source
connected via HDMI e/ARC/CEC. Dolby Atmos is not available for
OPTICAL, AUDIO IN or BLUETOOTH sources.
Equaliser
Press the MOVIE, MUSIC, VOICE or NIGHT button on the remote control
to select between preset equalisers.
Press EQ OFF to turn the preset EQ OFF.
EQ OFF
MOVIE
MUSIC
VOICE
NIGHT
The LED indicator will show for 5 seconds to confi rm the selection.
Adjust Bass and treble
Press the BASS or TREB on the remote control. Then press the
to change the custom bass and treble settings up or down.
The LED indicators show the level.
-6dB
-4
-2
0
2
4
+6dB
The LED indicator will show for 5 seconds to confi rm the selection.
LED dimmer control
Press DIM on the remote control to adjust the brightness of the units
LED's.
Choose from low, medium or high.
Auto standby
Long press EQ OFF to enable/disable Auto standby. By default, the unit
will go into standby if no signal is detected for 20 minutes on Optical,
Bluetooth and Audio In sources.
By turning Auto standby OFF, your unit will remain powered on even if
no audio is detected.
Auto standby
OFF
Auto standby
ON
EN
/
Advertisement
Table of Contents
