Additional Heater Fuel Cut-Off Switch; Fuel Cut-Off System; Lever Release - Opel MOVANO Owner's Manual

ADDITIONAL
HEATER FUEL
CUT-OFF SWITCH
The vehicle is fitted with a safety switch
that trips to cut off the fuel supply to
the additional heater in the event of a
collision.
278) 279)
Reactivating the additional heater
fuel cut-off switch
Press the button to reactivate the fuel
cut-off switch of the additional heater
(A) fig. 380.
380
IMPORTANT
278) If, after a crash, you smell fuel or
notice leaks from the fuel supply system,
do not reset the switch to avoid fire risk.
279) Before reactivating the fuel cut-off
switch, carefully check for fuel leaks or
312
damage to the vehicle electrical devices
(e.g. headlights).
FUEL CUT-OFF
SYSTEM
This intervenes in the case of a collision
causing:
the interruption of the fuel supply with
the engine consequently cutting out;
automatic unlocking of the doors;
turning on the lights inside the car;
deactivation of climate control system
ventilation;
switching on the emergency lights
(to disable the lights, run the "reset"
procedure as shown below).
On some versions, the intervention of
the system is indicated by a message
shown on the display. In the same way,
a dedicated message on the display
warns the driver if system operation is
compromised.
F1A0086
WARNING Check carefully for fuel
leaks, for instance in the engine
compartment, under the vehicle or near
the tank area.
After a collision, turn the ignition device
to STOP to prevent the battery from
running down.
Reset procedure In case of a minor
collision, simply turn the key to STOP
and then restart. In the event of a major
collision, you must call for assistance,
as restarting the vehicle is not possible.
AUTOMATIC
TRANSMISSION

LEVER RELEASE

In the event of a failure, to move the
gear lever from P (Park), proceed as
follows:
switch off the engine;
engage the parking brake;
working carefully in the point
indicated by the arrow, fig. 381,
remove the gaiter lifting it upwards;
381
depress the brake pedal and keep it
fully depressed;
insert the supplied screwdriver
perpendicular into the release hole
in the rear right corner of the gear
selector unit (fig. 382) and press the
F1A0707