Fix&Go Automatic Quick Tyre Repair Kit - Opel MOVANO Owner's Manual

fig. 369) to facilitate the extraction of the
spanner itself, to prevent the attachment
device from being released and the wheel
assembly not being securely retained.
270) Each time the spare wheel is moved,
check that it is correctly positioned in its
housing under the platform. If it is not
correctly positioned, this could adversely
affect safety.
271) The spare wheel lifting device is
equipped with a clutch safety system for
its own protection; this could activated
if an excessive load is applied on the
manoeuvring screw.
FIX&GO AUTOMATIC
QUICK TYRE REPAIR
KIT
(for versions/markets, where provided)
272) 273) 274) 114) 115) 6)
The Fix&Go tyre repair kit is located
at the front of the vehicle passenger
compartment and includes fig. 374:
374
a canister (A) of liquid sealant,
complete with clear filler hose (E); black
pressure top-up hose (C); sticker (D)
marked max. 80 km/h to be affixed in a
position in clear view of the driver (on
the dashboard) after the tyre has been
repaired;
a compressor (F) provided with an
electrical connector (H);
a pair of protective gloves located in
the spray can compartment.
REPAIR PROCEDURE
Proceed as follows:
stop the vehicle in a position that
is not dangerous for oncoming traffic
where you can change the wheel;
stop the engine, apply the parking
brake and engage 1 st or reverse gear;
before getting out of the vehicle,
put on the reflective safety jacket (if
required by the regulations in force). In
any case, follow the road safety laws
in force in the country where you are
driving;
insert the cartridge (A) containing
the sealant into the corresponding
compressor compartment (F) and
press it down hard until you feel the
locking mechanism click. Detach the
speed limit sticker (D) and apply it in a
clearly visible position;
insert the cartridge (A) containing
F1A0743
the sealant into the corresponding
compressor compartment (F) and
press it down hard until you feel the
locking mechanism click. Detach the
speed limit sticker (D) and apply it in a
clearly visible position;
wear the gloves;
remove the cap from the tyre valve
and connect and screw the transparent
tube of the sealing fluid (E) onto the
valve. Make sure that the ON/OFF
button is in the OFF position.
375
insert the electrical connector (H)
fig. 375 in the 12 V power socket of the
vehicle and start the engine;
operate the compressor by pressing
the ON/OFF button (ON position)
fig. 374. When the pressure gauge (B)
reaches the recommended pressure
(see the "Wheels" chapter in the
"Technical Specifications" section),
stop the compressor by pressing the
ON/OFF button again;
F1A0742
307