Door Locking; Doors - Opel MOVANO Owner's Manual

ACTIVATION
With the doors and bonnet closed and
the ignition key either turned to STOP
or removed, point the key with the
remote control towards the vehicle and
press and release the or lock button or
locking the vehicle using the Passive
Entry/ Keyless Entry system.
Excluding some markets, the system
produces an acoustic warning (beep)
and enables door locking.
The turning on of the alarm is preceded
by an self-diagnosis stage: if a fault is
detected, the system produces another
acoustic warning.
In this case, turn the alarm off by
pressing the "release doors/release
load compartment" button or
unlock the vehicle using the Passive
Entry/Keyless Entry system, check that
the doors and bonnet are properly
closed and turn the alarm back on by
pressing the lock button.
If a door or the bonnet is not properly
shut, it will be excluded from the testing
by the alarm system.
If the alarm produces an acoustic
warning even when the doors and
bonnet are correctly closed, a fault
has occurred in the operation of the
system. Always go to a Dealership.
WARNING The alarm does not come
on when the central locking is activated
using the metal insert of the key.
WARNING The alarm is adapted to
meet requirements in various countries.
DEACTIVATION
Press the "unlock door/unlock load
compartment" button on the key with
remote control or unlock the vehicle
using Passive Entry/Keyless Entry
system.
The following operations are performed
(excluding some markets):
direction indicators flash twice;
two brief acoustic signals ("beeps");
doors are unlocked.
WARNING The alarm does not
switch off when the central opening is
activated using the metal insert of the
key.
BREAK IN ATTEMPT
INDICATION
In the event of a break-in attempt, the
warning light on the instrument
panel turns on (see the "Warning
lights and messages" chapter in the
"Knowing the instrument panel"
section).
DISARMING THE ALARM
To permanently disable the alarm (e.g.
during a long period of inactivity),
simply lock the vehicle by turning the
metal insert of the key with remote
control in the lock.
WARNING If the batteries of the key
with remote control run out or in case
of a system fault, the alarm can be
switched off by placing the key in the
ignition device and turning it to MAR.

DOORS

DOOR CENTRAL
LOCKING/UNLOCKING
Locking from the outside
With the doors closed, press the
button on the key fig. 22, fig. 23,
fig. 24, fig. 25 or insert and turn the
metal insert (A) in the driver's door
lock clockwise. The doors will only be
locked if all doors are shut.
Press button (B) to open/close the
metal insert.
If one or more of the doors is open
after the button on the key is
pressed, the direction indicators and
the LED in the button (A) fig. 26 will
flash quickly for about 3 seconds. With
the function on, the button (A) fig. 26 is
disabled.
29