Table of Contents
Advertisement
> Super Function Setup
> South Onchip PCI Device
> South Onchip IDE Device
> South Onchip SATA Device
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Super IO Device
Please refer to section 3-7-1
OnChip IDE Device
Please refer to section 3-7-2
OnChip PCI Device
Please refer to section 3-7-3
3-7-1
Super IO Function Setup
Onboard FDC Controller
Onboard Serial Port1
UART Mode Select
IRDA Duplex Mode
PWROM After PWR-Fail
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port
Select an address and corresponding interrupt for the serial port. The settings are: 3F8/IRQ4,
2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this
functions uses.
IrDA Duplex Mode
This field is available when UART Mode is set to either ASKIR or IrDA. This item enables you
to determine the infrared function of the onboard infrared chip. The options are Full and Half
(default). Full-duplex means that you can transmit and send information simultaneously.
Half-duplex is the transmission of data in both directions , but only one direction at a time.
Press Enter
Press Enter
Press Enter
Press Enter
F6:Fail-safe Defaults
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Function Setup
Enabled
3F8/IRQ4
IRDA
Half
[OFF]
F6:Fail-safe Defaults
Menu Level >
F7:Optimized Defaults
Menu Level >>
F7:Optimized Defaults
28
Advertisement
Table of Contents
