Card Installation; Installing Msc And Line Cards; Figure 6 Chassis Frame Ground - ZyXEL Communications IES-5000 Series User Manual

IES-5000 Series User's Guide

Figure 6 Chassis Frame Ground

3.3 Card Installation

This section shows you how to install and remove chassis cards.
• Install the line cards in the IES-5000 starting from slot 3 downwards.
• Install the line cards in the IES-5005 starting from slot 2 downwards.
• Install management switch cards in slot 1 and/or 2 on the IES-5000.
• Install a management switch card in slot 1 on the IES-5005.

3.3.1 Installing MSC and Line Cards

Use the following procedure to install management switch cards and DSL line cards in the
chassis.
1 Grasp the center of the front panel of the card with one hand and place the other hand
under the card to support it.
2 Insert the card halfway into the slot and spread the two ejector levers outward. Make sure
the ejector levers are perpendicular to the front panel.
3 Slide the card into the slot until it makes contact with the backplane. The ejector levers
should be at a small angle to the front panel now.
4 Push the two ejector levers firmly until they are flush with the front panel.
5 Tighten the two thumbscrews.
30 Chapter 3 Hardware Installation and Connections