Table of Contents
Advertisement
3.1 Network connection with DSL / wired (continued)
To connect to the Livecam, the first step is to determine the IP that is currently used by
the camera computer.
•
If the Livecam will use a fixed IP, this fixed IP has already been sent to roundshot and
set in the network configuration of the computer, so you will be able to use that IP.
If the Livecam is obtaining its IP automatically through DHCP, there are two ways to
•
obtain its IP:
a.
By having the camera powered up and connected by RJ45 cable within the
network and using an IP scanner software (such as Angry IP Scanner:
https://angryip.org/download)
b.
By resetting the camera computer to a fixed IP (192.168.1.80) using a hardware
reset button -> see chapter 3.3 Network connection trouble-shooting
•
If all of the above fails, it is also possible to use the Livecam serial number to connect:
roundshot_############ where the last 12 digits represent the computer mac
address. This serial number can be found:
on the camera front panel (above lens)
o
on the Livecam invoice
o
by scanning the network for new IPs / mac addresses
o
by contacting roundshot
o
Bring your computer network configuration into the same range as follows – for example:
computer IP: 192.168.1.70
subnet mask: 255.255.255.0
gateway 192.168.1.1
Download VNC Viewer (RealVNC, not Ultra VNC) and connect to the camera computer:
Installation Manual Roundshot Livecam Generation 4 - April 2024 - © by Seitz Phototechnik AG / Switzerland
camera: 192.168.1.80
www.roundshot.com
page 20
Advertisement
Table of Contents
