Field Coating Touch-Up Procedure For Scratched Areas - Greenheck TDI Installation, Operation And Maintenance Manual

Field Coating Touch-Up Procedure for Scratched Areas

Standard coating color is RAL 7023 Concrete Grey. This procedure outlines the correct method for repairing minor
scratches in the coating.
1. Scuff affected area to be repaired using medium sandpaper (provided) or medium scotch brite pad. Feather the
edges.
TOUCH-UP PAINT REPAIR KIT CONTENTS
• One pint of Kem Kromik primer
- including a technical data sheet
• One pint of industrial enamel
- including a technical data sheet
• Four disposable foam brushes
• One sheet sandpaper
• Repair procedure details
2. Clean affected area to be touched up using an alkaline based cleaner and rinse.
3. Apply Kem Kromik primer using 1-inch foam brush (provided). Follow technical data sheet instructions.
4. Allow primer to dry a minimum of 2-1/2 hours before applying topcoat.
5. Apply topcoat with industrial enamel using 1-inch foam brush (provided). Follow technical data sheet
instructions. Allow painted units to air-dry and cure before putting into service. See Technical Data sheets
(included with kit) for detailed drying and cure schedules at different temperatures.
While the manufacturer provides heavy-duty, quality products for marine environments, routine paint touch-ups
may be required in coastal regions where salt or marine air could damage the coating on a TBI, TBI-CA or TBI-FS.
The severe environment will accelerate the damage from any scratches or chips and it is recommended that those
be repaired immediately.
To order additional coating repair kits, reference part number HAZ2597 PNT FIELD REPAIR KIT, RAL 7023
CONCRETE GREY. Contact factory with your fan's serial number for colors other than our standard.
6 Tubular Inline Fans
NOTE
®