AMD SB700 User Manual page 19

(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
• Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
(10) Serial-ATAII Port connector: D- SATA1, D-SATA 2, D-SATA3
This connector supports the provided Serial ATA2 IDE hard disk cable to connecting
the motherboard with serial ATAII hard disk. E-SATA1 is not for SATA hard drive ,it
is only for connecting to D-SATAII 1,D- SATA II 2, D--SATA3 to let the ESATA port
work.
Floppy Drive Connector
IDE1
Primary IDE Connector
14
FDD
Pin 1
Pin 1