GE Performance JS966 Technical Service Manual page 19

SLIDE RANGE INTO OPENING
Position the range in front of the
E1
cabinet opening.
Make sure that the glass which
E2
overhangs the countertop clears the
countertop. Raise the unit by lowering
the leveling legs if necessary.
Push while lifting the range into the
E3
opening until the range is within 2" of
engaging the anti-tip bracket.
Remove the protective trim from the
E4
side of glass. (If provided)
Using the adjustable pliers or wrench
E5
carefully screw in the back leveling leg
until the glass overhang comes to rest
on the counter top.
Adjustable Wrench
or Pliers
Then carefully screw in the front two
E6
leveling legs (similar to E5) until the
glass overhang touches the
countertop.
Carefully push the range into the
E7
opening until the counter top fully
engages the control panel. The back
glass overhang should cover the cutout
opening.
Make sure the edge
of the countertop fits flush
against the end of the
Front Control Panel
Plug range cord into receptacle. Locate
E8
the cord in the back of the range in a
manner that will not touch or be moved
by the drawer.
POSITION RANGE CORD
SO THAT THERE IS NO
INTERFERENCE WITH
STORAGE DRAWER
STORAGE DRAWER
17
Countertop
GEA01053