Lubrication Table - Cub Cadet 1782 Owner's Manual

LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Anti cipated Air Tempera ture
Above +77°F +32°F to 77°F
Below 32°F
Engine crankcase
Check
before
each
use
35
and
100
Approx.
3.4 qts
including
oil in oit
filter
Engine Oil
SAE-30
Grade CD
Engine Oil
SAE -20 or
SAE-15W-40
Grade CD
Engine Oil
SAE-10 or
SAE-10W-40
Grade CD
Hydro-drive unit
mounted on trans¬
mission case with
filter
Check
before
each
use
Add
as
needed
Approx.
14 pints
Cub Cadet Hydraulic Transmission Fluid
NOTE: Cub Cadet hydraulic transmission fluid meets
IH B-6 specifications. If fluid is used that does not
meet these requirements, Cub Cadet will not be respon¬
sible for substandard performance. Failures due to use
of improper fluid are not covered by warranty. For
maximum protection, use Cub Cadet Hydraulic Trans¬
mission Fluid.
Steering knuckles &
front axle pivot bolt
10
Use 251H EP grease or equivalent No. 2 multi-purpose
lithium grease and apply two or three strokes or suffi¬
cient grease to flush out old grease and dirt.
Front wheel
bearings
35 Two or three strokes minimum of the lubricator using
251H EP grease or equivalent No. 2 multi-purpose
lithium grease.
Alignment couplings 251H EP grease or equivalent No. 2 multi-purpose
lithium grease.