Table of Contents
Advertisement
LUBRICATION TABLE
Point of
Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Anticipated Al r Temperature
Above +32°F
Below +32°F
Engine crankcase
Check
before
each
use
100
Approx.
4 pints
Cub Cadet
Engine Oil SAE
10W30 or 10W40
Cub Cadet
Engine Oil SAE
5W20 or 5W30
Hydro-drive unit
mounted on
transmission
case with filter
Check
before
each
use
Add as
needed
Approx.
14 pints
Cub Cadet
Hydraulic Transmission Fluid
NOTE: Cub Cadet
hydraulic transmission fluid
meets IH B-6 specifications, if fluid is used that
does not meet these requirements,
Cub Cadet
will not be responsible for substandard perform¬
ance. Failures due to use of improper fluid are not
covered by warranty. For maximum protection,
use
Cub Cadet
Hydraulic Transmission Fluid.
Steering knuckles
& front axle pivot
bolt
10
Use 251H EP grease or equivalent No.2 multi¬
purpose lithium grease and apply two or three
strokes or sufficient grease to flush out old grease
and dirt.
Front wheel
bearings
30
Two strokes of the lubricator using 251H EP grease
or equivalent No. 2 multi-purpose lithium grease.
Lift shaft
30
Two strokes of the lubricator using 251H EP grease
or equivalent No. 2 multi-purpose lithium grease.
Drive shaft
100
CV^Joint grease or Polyrex grease Part No.
737-3023 - use sufficient amount to make rubber
boot coupling swell.
Steering gear
housing (1863
only)
100
Two strokes of the lubricator using 251H EP
grease or equivalent No. 2 multi-purpose lithium
grease.
35
Advertisement
Table of Contents
