Cub Cadet 1782 Owner's Manual page 9

F. PREHEAT INDICATOR
This indicator is used to assist in cold starting of the
tractor.
G. REVERSE "R" INDICATOR
This indicator is illuminated when the tractor is in
reverse. The reverse "R" indicator must be off before
the tractor can be started.
H. DISENGAGE PTO INDICATOR
This indicator will illuminate if an attempt is made to
start the tractor with the PTO switch engaged. This
indicator must be off before the tractor can be started.
When starting the tractor, this indicator will briefly
flash.
I. DEPRESS LEFT PEDAL INDICATOR
This indicator will illuminate when an attempt is made
to start the tractor with the single brake pedal not fully
depressed.
J. SPEED CONTROL LEVER
NOTE
Do not rest your foot on the single brake
pedal while driving the tractor as this would
cause the speed control lever to return to the
"N" position.
The lever is used to select any speed from a standstill
"N" position to eight miles per hour in the forward
direction and four miles per hour in the reverse direc¬
tion.
Moving the speed control lever forward provides
increased forward speed, and moving the lever rear¬
ward provides the reverse speeds. (See Figure 3.)
K. CAM LOCK KNOB
The cam lock knob is used to adjust the cam stop,
which will allow an attached implement to return to a
single preset height. (See Figure 4.)
With the implement at a desired height, release cam
stop by turning locking knob counterclockwise. Turn
cam stop until it contacts tang. Lock cam stop into this
position by turning cam knob clockwise.
Equipment is normally operated in a "Float" position
(implement free to move upward).
To operate equipment in a fixed "Locked" position,
where down pressure of the implement is required
(blade work), remove frame cover and install bolt, 1/2
x 1-1/8 inch (not furnished with tractor), between the
lift arm and lift bracket. (See Figure 5.)
1. Locking Knob
2. Cam Stop
3. Tang
Figure 5
1. Lift Bracket
2. Hole for Bolt
3. Lift Arm
L. TURNING BRAKE PEDALS
A
CAUTION
Use the two turning brake pedals only at low
speeds to maintain control of the tractor
when using rear mounted equipment.
The two turning brake pedals are used for individual
braking of the rear wheels to aid in turning the tractor
in soft soil conditions. (See Figure 6.) Depress the
outside turning brake pedal to slow or stop the right
rear tractor wheel; depress the inside turning brake
pedal to slow or stop the left rear tractor wheel. The
tractor will turn in the direction of the wheel that is
slowed or stopped.
9